Equinox Systems MEGAPLEX Bedienungsanleitung PDF herunterladen (Seite 151)

AMIS Analog Networking

585-300-512 Issue 7

May 1999

Intuity System AMIS Administration

5-27AMIS Remote Machine Administration

6. Enter a start time in the

start

field.

Use the format HH:MM where HH stands for hours and MM stands for

minutes. Specify the time using a 24-hour or military time clock. For

example, if you want the start time to be 11:00 p.m., enter 23:00 in the

field.

7. Enter an end time in the

end

field.

Use the format HH:MM where HH stands for hours and MM stands for

minutes. Specify the time using a 24-hour or military time clock. For

example, if you want the end time to be 12:00 a.m., enter 00:00 in the field.

8. If you need to establish multiple send times, repeat steps 6 and 7 for the

second and third schedules. If you need to establish only one schedule,

proceed to step 9.

Up to three cycles can be defined for each remote system. Cycles may be

assigned to avoid toll facilities or periods of heavy traffic if desired. The

total time of the cycles can neither exceed 24 hours nor overlap. A cycle

can span across midnight.

NOTE:

The times specified must be equal to or a subset of the outcalling

transmission times administered on the System Parameters

Outcalling screen, or the AMIS and/or message delivery messages

will never be sent. For example, if you schedule AMIS and message

delivery messages to be sent anytime during a 24-hour period

(00:00 to 23:59), but outcalling periods are only scheduled from

07:00 to 18:00, AMIS and message delivery messages are sent

between the hours of 7:00 AM and 6:00 PM.

If all the outcalling ports are busy, the system retries in one minute. If an

outcalling port is available, but for some reason the system cannot deliver

the message, the system uses the value entered in the

Rescheduling

Increments For Unsuccessful Message Delivery

field on the

System Parameters Features screen.

AMIS message delivery is done in packets of 9 to satisfy the AMIS

standard. Any messages left in the queue are rescheduled for immediate

delivery after the first 9 are transmitted. The local system calls the remote

system again within 2 minutes and transmits any additional AMIS

messages in the queue.

9. When you finish entering information for a remote machine, press

(F8) then press (F3) to enter the information into the

system.

After you press the key, the system adds the information and returns you

to the

Machine Name

field. You see the following message on your

screen:

Machine Added, Enter Machine Name, use <CHOICES> for

list

CHG-KEYS

ADD

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 237 238

Kommentare zu diesen Handbüchern

Keine Kommentare

Equinox Systems MEGAPLEX Bedienungsanleitung Seite 151

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Equinox Systems MEGAPLEX